EUTECH INSTRUMENTS ALPHA CON 500 2-WIRE TRANSMITTER Provozní pokyny Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 34
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
23
7.4.3 Reverting to factory default settings
Use this parameter to reset all settings to factory default. Changing from “no”
to “YES” and pressing the ENTER key resets all settings to factory default.
WARNING: If “Yes” is selected, all settings input
will be overwritten!
1) Follow directions in 7.4.1 to enter Configuration
mode.
2) Press the ENTER key. Scroll with the
or
keys until the upper
display shows “no” or” YES”, and the lower display shows “deF” (default).
3) Press the
or
keys to select no or yes. Selecting “YES” and pressing
the ENTER key will overwrite all user-settings and automatically return to
Measurement mode.
4) Press the ENTER key to confirm your selection and return to Advanced
Set-up mode, or return to Measurement mode by pressing the
and
keys
simultaneously (escape).
7.5 Calibration (CAL) sub-function
The calibration procedure in Advanced Set-up mode is identical to the
procedure in the Calibration mode. The only difference is that the controller
will revert back to Set-up mode (instead of Measurement mode) after
calibration is completed.
7.5.1 Entering Calibration mode from Advanced Set-up mode
1) Enter Advanced Set-up mode. Press the ENTER key.
2) Press the
or
keys to scroll until the upper display shows “CAL”.
3) See section 6 for complete calibration procedures.
no
dEF
SETUP
HOLD
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Komentáře k této Příručce

Žádné komentáře