EUTECH INSTRUMENTS ALPHA PH1000 PHORP CONTROLLERTRANSMITTER Manuál s instrukcemi stáhnout pdf (Strana 26)

7.6 Configuration (ConF) sub-function

This group of parameters lets you configure the controller to suit your requirements.

7.6.1 Entering the Configuration sub-function

1) Enter Advanced Set-up mode. Press the ENTER key and scroll to Advanced Set-up

security code “22”. Press the ENTER key again.

2) Press the ▲ or ▼ key to scroll until the upper display shows “ConF”.

7.6.2 Selecting pH, ORP% or ORP mV measurement

This parameter group lets you select pH, mV, or % readings, and input type symmetrical or

asymmetrical. Symmetrical mode is used in conjunction with a potential matching pin – in an

electrically noisy environment.

Please refer to section 3, page 6 for a graphical representation.

1) Follow directions in 7.6.1 to enter Configuration mode.

2) Press the ENTER key. Scroll with the ▲ or ▼ key until the upper display shows the control

type (pH, ORP mV or ORP %) and the lower display shows symmetrical (SY) or

asymmetrical (ASY) input type. Choose ORP without the mV indicator for ORP% readings.

3) Proceed to 7.6.3, or return to Measurement mode by pressing the ▲ and ▼ keys

simultaneously (escape).

SETUP

HO LD

SETUP

HO LD

SETUP

HO LD

SETUP

HO LD

ASy

SETUP

HO LD

SETUP

HO LD

SETUP

HO LD

Asy ASy

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

Žádné komentáře

EUTECH INSTRUMENTS ALPHA PH1000 PHORP CONTROLLERTRANSMITTER Manuál s instrukcemi Strana 26