EUTECH INSTRUMENTS DO 6 - REV 2 Manuál s instrukcemi stáhnout pdf (Strana 35)

Instruction Manual CON 6/TDS 6

2) Press ▲ or ▼ key until [tdS] appears on the LCD. Press ENTER key.

3) Press ▲ or ▼ key to select a value between 0.4 to 1.0.

4) Press ENTER key to select. The meter will take you back to the menu,

[tdS].

5) Press ▲ or ▼ key to move to the next menu or press CAL to exit to

measurement mode.

6.5 Temperature Coefficient

The temperature coefficient is the amount of change in conductivity per degree

of temperature; it is expressed in percent per °C. Entering the exact

temperature coefficient of your solution lets you accurately compensate

temperature for almost any solution. You can adjust 0.0 to 3.0 % per °C.

Meter default is 2.1% per °C.

6) Enter the advanced setup as described in

Section 6.1.

7) Press ▲ or ▼ key until [t.Co %] appears on the

LCD. Press ENTER key.

8) Press ▲ or ▼ key to select a value between 0.0

to 3.0.

9) Press ENTER key to select. The meter will take

you back to the menu, [t.Co %].

Press ▲ or ▼ key to move to the next menu or press

CAL to exit to measurement mode.

HOLD

ENTER

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Žádné komentáře

EUTECH INSTRUMENTS DO 6 - REV 2 Manuál s instrukcemi Strana 35