EUTECH INSTRUMENTS CYBERSCAN DO 1500 DO METER Manuál s instrukcemi stáhnout pdf (Strana 15)

Instruction Manual DO 300

NOTE: To select between mg/L and ppm units, see Section 8.7.2 on page 30.

The ATC indicator should appear in the lower right hand corner of the display. If it does not,

this indicates an error.

Taking measurements with READY ON indicator selected on

If the READY indicator has been activated, the READY annunciator lights when the reading is

stable.

To enable or disable the READY indicator – see Section 8.7.1 on page 29 for directions.

Taking measurements with READY HOLD indicator selected on

When a reading is stable for more than 5 seconds, the

auto endpoint feature will automatically “HOLD” the

reading. The “HOLD” indicator appears on the left side of

the display. Press the HOLD key to release the reading.

To enable or disable the Auto endpoint feature– see

Section 8.7.1 on page 29 for directions.

(The values shown above are for illustration purpose. Your meter may display

different values depending on the settings & your environmental conditions)

Figure 11 – Auto endpoint

feature

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Žádné komentáře

EUTECH INSTRUMENTS CYBERSCAN DO 1500 DO METER Manuál s instrukcemi Strana 15