EUTECH INSTRUMENTS CYBERSCAN DO 5000 DO METER Manuál s instrukcemi stáhnout pdf (Strana 54)

Instruction Manual PD 300

8.12 P7.0 [6.0] rSt: Resetting to Factory Default Setting (DO)

This program lets you reset all DO (% saturation and mg/L) parameters to factory default

settings. This clears all calibration data and any other DO setup functions you might have

changed.

The following settings will remain as you have set them:

• Temperature unit of measure (°C or °F)

• The temperature offset calibration value

• All DO calibration data and parameters

There are also some other parameters that retain settings when reset is done. See Addendum

3 on page 68 for a table of factory default settings.

From measurement mode

Figure 41: Reset to factory

defaults

1. Press SETUP key to enter SETUP mode.

2. Press ▲ or ▼ keys to scroll through su/jointfilesconvert/267593/bgroups

until you view parameter “rSt” in the upper display.

3. Press the ENTER key.

4. Press ▲ or ▼ keys to toggle between NO and

YES.

• NO retains current memory.

• YES clears all memory

5. Press the ENTER key to confirm selection and to

return to measurement mode.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 75 76

Žádné komentáře

EUTECH INSTRUMENTS CYBERSCAN DO 5000 DO METER Manuál s instrukcemi Strana 54