EUTECH INSTRUMENTS WP PCD 650 Manuál s instrukcemi stáhnout pdf (Strana 79)

Instruction Manual PCD 650

4. Setup Mode

4.1 About Setup Mode

The setup mode lets you configure various parameters & settings of the meter. You

can choose to password-protect your settings, so that other users who may use the

meter will not be able to change the settings.

Setup mode consists of the following sub-groups:

 System – General settings of the meter

 pH/mV/Ion/Conductivity/TDS/Salinity/Resistivity/O

mg/L (ppm)/ O

(%)

– The pH/mV/Ion/Conductivity/TDS/Salinity/Resistivity’s/O

mg/L (ppm)/ O

(%) Setup screen presents many options to control the operating

parameters of their respective mode.

 Temperature - Temperature measurement & calibration related settings.

4.1.1 Accessing Setup mode (no password protection enabled)

1. Switch on the meter. The meter goes to measurement mode.

2. Press left or right arrow key on the keypad to navigate to other available

functions until you see SETUP function in the LCD.

3. Press SETP (F1) and Setup Key Function screen appears. This page

describes the keys functions for configuring various parameters and settings of

the meter.

Figure 65: Setup Key Function screen

Note: If the meter is password protected, you will be prompted to enter a

password before accessing Setup Key Function screen. Refer ‘Accessing

Setup mode when password protection enabled’ in page 73 for details.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 119 120

Žádné komentáře

EUTECH INSTRUMENTS WP PCD 650 Manuál s instrukcemi Strana 79